P. 563-872-4112 | F. 563-872-5058 | Email: office@jjscheckel.com | 21582 Hwy 62, Bellevue, IA 52031
EQUIPMENT FOR SALE

2004 Cat D10T, Crawler Tractor, A02730

2004 Cat D10T, RJG series, 23,037 hours, midlife component hours listed below, Single Shank Ripper, U Blade, Twin Tilt, Cat Dealer maintained, Serviced and ready to go. Read the Details:
                                                      
·  RJG Series
·  23,037 total frame hours,
·  4,701 idle hours, ECM verified

Component History
·  9,931 hours on Engine and Torque, Rebuilt by Cat Dealer before failure.
·  7,471 hours on Steering clutches and Brakes, Rebuilt by Cat Dealer.
·  454 hours on turbos.
·  100 hours on resealed track frames, pivot shaft, and equalizer bar. By Cat Dealer.
·  0 hours on all the fluids and filters, serviced in house. We also fixed several oil leaks, tested machine pressures, rebuilt some hyd cylinders, rebushed any loose ripper joints, and went thru machine and tested and fixed anything we visually noticed so machine was essentially rent ready.

·  We can email all service history, and testing reports.
 
·  Enclosed Cab, A/C, Heat
·  Single Shank Ripper  (Shank available at extra $4,500 cost)
·  U blade w/ twin tilt, solid face
·  Engine Enclosures
·  Pretty fair and straight sheet metal
 
·  This tractor was freshly sandblasted and painted, using OEM quality polyurethane paint, and OEM decals.
 
·  Cat C27, 646 HP Engine
·  147,000 lbs operating weight
 
Undercarriage measures as follows (based on Cat spec, w/ 120% remaining being new):
·  Rail/Chain height measure 34% Remaining
·  Bushings on the chain measure 38% Remaining
·  Pads/Grousers measure 75% Remaining – 28” Pads
·  Sprockets measure 82% Remaining  
·  Qty 2, Front Idlers average 50% Remaining
·  Qty 2, Rear Idlers average 112% Remaining
·  Qty 16, Bottom Rollers average 80% Remaining
 
This machine starts, runs and operates as it should. The machine has had all oils and filters serviced, Component Pressures tested, several hoses replaced, leaks fixed, and some cylinders rebuilt. We line bored and rebushed some loose joints on the Ripper, and Blade. The machine was blasted and painted in our shop with OEM quality polyurethane.
 
We invite your own personal or 3rd party inspection of this machine anytime, located at our facility in Bellevue, Iowa. Priced to Sell.  
 
Nationwide Delivery, Export, and Financing available at very good rates.

 

Price: $350,000

     Email