2003 Cat D6R XL Crawler Tractor ~ A02634
2003 Cat D6R XL, 6,730 total frame hrs, 2,355 Idle hrs recorded, PAT 6 way Blade, Erops, A/C, Diff Steer, Multi shank Ripper, Excellent Undercarriage, Ready to go! Read the details -
· AAX serial number, Series 2
· 6,730 Total Frame Hours, ECM verified
· 2,355 hours where at Idle, ECM verified
· Only 4,375 actual operating hours on this machine
· 1,450 lifetime average RPM recorded
· 5.12 lifetime gallons per hour fuel burned, recorded
· 46% lifetime load factor recorded.
· Low Utilization Stats!
· Current Oil samples available
· Original condition, original paint, except for UC, track frames and Blade touched up.
· Factory Enclosed Cab, A/C, Heat
· Engine Enclosures
· Diff Steer
· PAT, Power Angle Tilt, (“ 6 way blade ”)
· Factory, Cat, Rear Multi Shank Ripper, with 2 shanks.
· Excellent Undercarriage, see full report below.
· Cat C9 Accert Engine, 210 HP
· 48,500 Pounds, operating weight
· 11’6” blade width
Undercarriage measures as follows, (Based on Cat spec 120% being New)
Cat OEM, Undercarriage on this machine.
· Rail/Chain height measure 112% Remaining
· Links/Bushings on rails measure 88% Remaining
· Pads/Grousers – 105% Remaining, 22” wide Track pads
· Sprockets – 120% remaining
· Front Idlers – 115% Remaining
· Rear Idlers – 120% Remaining
· Bottom Rollers – Average 112% remaining, on 14 bottom rollers.
This is a hard machine to find, set up like this, with the PAT blade and ripper. If you want a good one, here it is. Was Dirt machine for large energy contractor. The machine is straight, clean and original. Good solid condition all the way around. Hours are original and verified thru the ECM download.
This machine is currently getting an extensive pre sale work order, including a full Cat TA2 technical inspection of all component pressures to cat spec, we are also servicing all oils and filters on machine, along with several other pre sale procedures. This machine will be ready to go. Please call or email for additional information that we can email you –
We invite your own personal or 3rd party inspection of this machine anytime, located at our facility in Bellevue, Iowa. Priced to sell!